wraphoogl.blogg.se - Weathersnoop manual

#Weathersnoop manual manual
#Weathersnoop manual android

Make sure the app is allowed Bluetooth permission.

#Weathersnoop manual android

If you are getting a "Hub not found" error message, first make sure the app has permission to use Bluetooth on your device.įor Android devices: Enable Location Services.Įnabling location services is necessary to scan for Bluetooth LE devices.įor iOS devices running new iOS 13: Following the new iOS 13 update, Bluetooth permission may have been disabled. Bluetooth Connection Issues Hub not found

See Batteries in AIR & SKY for more info on battery installation and using the solar power accessory.

Make sure the arrows on the solar power accessory are aligned with those on the base of the SKY unit.

Make sure the batteries are fresh and inserted properly.

Check the batteries or solar power accessory connection. If the LED is not illuminating at all on the base of the unit, there could be a power supply issue. Use a thin tool to pass through the slit in the solar panel and press and hold the clear button and release once the LED flashes green. Using SKY solar panel accessory: There should be plenty of charge on the solar power accessory to supply power to the SKY unit out of the box.

Press and hold the clear button on the base of the unit and release once the LED flashes green.

If the LED is not slowly blinking green, reset the device to put it in pairing mode.

Continue with the setup procedure in the app.

You can peer through the openings on the bottom of the solar power accessory to view the LED status on the base of the SKY unit.

After a few seconds the LED will be slowly blinking green, indicating the device is in pairing mode and awaiting connection to a Hub.Power cycle the device, either open and close the battery door and/or detach and reattach the solar power accessory. Make sure to realign the arrows on the accessory and the base of the SKY unit.In order to connect to the Hub, AIR and SKY must be in pairing mode, indicated by a slow blinking green LED on the base of the unit. Reboot your Hub and your WiFi router as well as any range extenders.

#Weathersnoop manual manual

If your network is hidden, choose Manual Setup and enter the SSID.

The Hub does not require large or fast data transfer. The HUB only communicates on a 2.4GHz network which offers greater range than 5GHz.

Make sure your router is broadcasting a 2.4 GHz band network.

Tap 'Refresh' in the top right on the WiFi Setup screen in the Tempest Weather app.

If you are having trouble locating your WiFi network, try the following suggestions.

Hub loses WiFi connection - "Station offline".

If you're looking for Tempest System troubleshooting, see Tempest Troubleshooting Guide (Initial Setup, WiFi, Hub & Tempest device) This guide is only intended for the legacy Smart Weather Station.